After market plastics ...help

[THROTTLEMONSTER]

Anyone know of a good afermarket place to get plastics from... any advice is helpfull Thanks

[munky]

cheapest is China stuff on Ebay.

[.Cheetah.]

+1.... Theyve come along way with these........

[B Mac]

+1.... Theyve come along way with these........

I hope they are better than the set Krash had on my CBR. All the tabs are glued on, and 90% of them have broken off. My Hannspree Fairing will never be used again as the upper fairing's tab have broken off.


My solution to this is I'm taking a set of track fairings, and cutting holes for the factory headlights. They are 1,000,000,000,000,000,000 easier to take off than factory Honda fairings. I may retain the Hannspree tail section as it doesn't use tabs to mount it. I will use it so I have my so called trunk space. CBR's have the absolute worst trunk space. The registration barely fits in there.

[{Morbid}]

My solution to this is I'm taking a set of track fairings, and cutting holes for the factory headlights. They are 1,000,000,000,000,000,000 easier to take off than factory Honda fairings. I may retain the Hannspree tail section as it doesn't use tabs to mount it. I will use it so I have my so called trunk space. CBR's have the absolute worst trunk space. The registration barely fits in there.

I was thinking the same thing looking around at plastics before.

The China/Japan fairings have always gotten VERY bad reviews and a lot of sites that sell them and on quite a few forums. Mostly due to poor fitment problems that require modification of some kind to get them to fit/line up the way they should. Im sorry, but if Im going to spend any amount of money on something that says they are either predrilled, prefitted or both.....then it BETTER fit without needing modification.

[halliwood]

this is where I got mine, they will do a custom paint job on the fairings from photoshop and no glued tabs also sent me a tinted double bubble with the set.

http://www.motorcyclefairingsource.com/

here's the gif I did of them going on piece by piece

[THROTTLEMONSTER]

nice man awesome

[Danhor7]

Did you give your ZX10 some character?

[Slimer]

the 2 sets of ebay plastics i used just required a lot of tugging and pulling to fit. the one set that got crash tested looked like they got pushed through a meat grinder, they disintegrated on contact.

[munky]

the 2 sets of ebay plastics i used just required a lot of tugging and pulling to fit. the one set that got crash tested looked like they got pushed through a meat grinder, they disintegrated on contact.

You get what you pay for. I think spoolin' put the Ebay set on my 1000RR, and there's not much left.